Cisco Ap Light Codes. MT Troubleshooting Guide Cisco Meraki Documentation I re-created this scenario by connecting a 1702i to my 5508 WLC running firmware version 8.0.115.0, and got the same results Status LED constantly red: no clients are connected -> I would expect a green light Status LED constantly blue: Wifi-Clients connected -> ok, as expected, Clients are connected normally Inline Power ok: 26,1 Watt WLC / SW Version: 8540 / 8.2.151.0 5508 / 8.3.112.0 Same.
Access Point Reference Guide from support.cadetnet.org
Introduction Once you have your Cisco Business Wireless network set up and running, a blinking green LED indicates that an access point is ready to receive clients After you have mounted the access point, connect and power up the Access Point.
Access Point Reference Guide
Introduction Once you have your Cisco Business Wireless network set up and running, a blinking green LED indicates that an access point is ready to receive clients But what about when the AP is booting up? Bootup LED codes are a little more complex. A solid green LED indicates that at least one client is attached
Wireless Access Points Cisco. Cisco Access Point LED Status Checking the Lightweight Access Point LEDs If your lightweight access point is not working proberly, you can check the Status, Ehternet, and Radio LEDs When the power up sequence is complete: the LED displays a light green color to indicate that it is ready for operation
The Ultimate Guide to Cisco Switches Cisco Catalyst Switches. But what about when the AP is booting up?Bootup LED codes are a little more complex the LED displays a blue light when a client associates to the access point.